Inserting The Batteries Into The Remote; Power Connection; Antenna Connection - Nikkei NL22MSMART Manual Del Propietário

the Left or Right direction button and press OK to see
available options.
3.5. More Apps
In order to manage the apps installed on your TV,
you can use this option. Highlight and press OK. You
can add an installed app to Home menu, launch or
remove it. Highlight an app and press OK to see the
available options.
3.6. Market
You can add new apps from the application market
using this option. Highlight and press OK. Available
apps will be displayed. You can also access the
application market from within the More Apps menu.
3.7. Accessibility
You can access the accessibility settings menu directly
using this option.
3.8. Privacy Settings
You can access the privacy settings menu directly
using this option. This option may not be available
depending on the model of your TV and the selected
country during the first time installation process.
4. Settings
You can manage the settings of your TV using the
options of this menu. Refer to Settings Menu Content
section for more information.
You can reset your customisations on the Home menu
to defaults using the Reset Apps option (availability
depends on TV model and its features). Highlight and
press OK. A confirmation message will be displayed.
Highlight Yes and press OK to proceed. Note that you
will not be able to perform this operation again within
the next few minutes.
5. Sources
You can manage your input source preferences using
the options of this menu. To change the current source
highlight one of the options and press OK.
5.1. Source Settings
You can access the source settings menu directly using
this option. Edit the names, enable or disable selected
source options.

Inserting the Batteries into the Remote

The remote may have a screw that secures the battery
compartment cover onto the remote control (or this may
be in a separate bag). Remove the screw, if the cover
is screwed on previously. Then remove the battery
compartment cover to reveal the battery compartment.
Insert two 1.5V - size AAA batteries. Make sure the (+)
and (-) signs match (observing correct polarity). Do not
mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. Secure the
cover again with the screw, if any.
A message will be displayed on the screen when the
batteries are low and must be replaced. Note that when
the batteries are low, the performance of the remote
control may be impaired.
Batteries should not be exposed to excessive heat
such as sunshine, fire or the like.

Power Connection

IMPORTANT: The TV set is designed to operate on
a 12 V DC supply. For this, an adaptor is used which
gives 12 V voltage. Connect this adaptor to a system
that supplies 100-240V AC, 50/60Hz.
After unpacking, allow the TV set to reach the ambient
room temperature before you connect the set to the
mains.
1. AC adaptor
2. Power Input, DC 12 V terminal
Important safety information
Be sure to ground the connection
Connect the ground terminal of the AC
adaptor with the ground terminal provided at
the power outlet using the enclosed power
cord. If the provided plug does not fit your
outlet, consult an electrician for replacement
Surely connect the ground wire.

Antenna Connection

Connect the aerial or cable TV plug to the aerial input
(ANT) socket or satellite plug to the satellite input (LNB)
socket located on the rear side of the TV.
Rear side of the TV
English - 6 -
1
properly
of the obsolete outlet.
2