Kohler Lodern K-27939-CP Guia De Inicio Rapido

Tools
• Tape Measure
• Pencil
• Drill and 3/16" Bit
• Side Cutters
Hardware Placement
Measure and mark the attachment locations for the hardware on the drawers.
Drill a 3/16" (21 mm) hole at each marked location.
From inside the drawer, insert a screw through one of the holes. Count the number of visible
notches on the screw that appear from the other side.
Remove the screw and using a pair of side cutters, cut the screw at the appropriate notch. Repeat
for each screw.
Insert a screw through each hole, and align with a handle. Thread the screws into the handle.
Repeat for each handle.
Positionnement de la visserie
Mesurer et marquer les emplacements des attaches pour la visserie sur les tiroirs.
1470609-2-A
Outils
• Mètre ruban
• Crayon
• Perceuse et mèche de 3/16 po
• Couteaux latéraux
Centered Side to Side
Centré Côte à côte
Centrado lateralmente
1
1470609-2
Herramientas
• Cinta para medir
• Lápiz
• Taladro y broca de 3/16 pulg.
• Pinzas de corte
4-1/8"/ po
(105 mm)
4-1/8"/ po
(105 mm)
Kohler Co.