Installing The Ydo01C-Bt (Option B2) - Sartorius YBT01 Instrucciones De Funcionamiento

Installing the YDO01C-BT
(Option B2)
! Because the installation of the YDO01C-BT (Option
B2) entails opening the indicator housing, it must be
performed by a technician with relevant training
(i.e., a service technician). Failure to observe the
applicable restrictions and regulations when opening
the indicator housing will result in forfeiture of all
claims under the manufacturer's warranty.
§ Attach the PCBs
§ Remove the protective cap from the back of the
indicator housing
§ Pull the antenna cable through the opening
§ Fasten the nut by hand and then use an open-ended
wrench (19 mm) to tighten the antenna connector
carefully
§ Plug the antenna into the angle plug and tighten it
by hand
§ Use an open-ended wrench (8 mm) to tighten the
antenna carefully
15