For Battery Tools - Worx MAKERX Manual Del Usuario

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ASSEMBLY
1. Fitting the nozzle. (See Fig. A1, A2, A3, A4)
Long nozzle and short nozzle are suitable to dust surfaces. The difference between
them lies in the air force. A short nozzle is more powerful.
Brush adapter should be equipped with long nozzle or short nozzle to use.
Air blade nozzle is used to clean up trash and dust in crevices.
In addition to cleaning, tip nozzle and air blade nozzle can be used for painting.
2.Connect the mini blower to the hub. (See Fig. B)
WARNING: Before operation, make sure the speed control button on the
hub is at the"Min" position. (See Fig. C)
OPERATION
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip. Press
the on/off switch on the hub and that on the mini blower to start the machine. (See
Fig. D)
WARNING: Never use tools with defective On/Off switch. In the case of all other
types of technical faults, please contact helpline or local service center.
2. Adjust speed as needed. (See Fig. E)
EN
The air speed is adjustable for a wide range of applications. High speed can be used
12
to dust electronic devices, such as a computer keyboard, laptop, copy machine,
medical equipment, camera, model vehicles, and blinds etc. And low speed can be
used for acrylic painting.
NOTE: After usage, press the on/off switch on the mini blower and that on the hub to
turn off the machine and disconnect it from the hub. For sake of safety, adjust the
speed control button to "Min" position once completing the operation.
MAINTENANCE
Remove the battery pack from the tool before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.

FOR BATTERY TOOLS

The ambient temperature range for the use and storage of tool and battery is 0
(32°F-113°F).
The recommended ambient temperature range for the charging system during charging
C C
0 0
is 0 -40 (32°F-104°F).
C C
0 0
-45