Descargar Imprimir esta página

Whirlpool CAE2761KQ0 Guia De Inicio Rapido página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

A quencher is located in the wiring harness near the water level switch on the washer and screwed to the cabinet of the
gas dryer in front of the burner assembly. The quenchers are designed to reduce EMI from the water level switch or gas
valve when they change state. EMI generated from a switch state change may cause the electronic control to reset during
a cycle when a quencher has failed or has been removed.
Kit 3952286 is designed to replace the water level switch quencher on EMS1000 washers built prior to 1999. Starting with
1999 production the water level switch quencher is integral to the wiring harness necessitating harness replacement for
quencher failure.
PRODUCT
EMS1000
WASHERS
PRIOR TO 1999
EMS1000 AND
ADVANTECH™
WASHERS
AFTER 1999
EMS1000 AND
ADVANTECH™
GAS DRYERS
EMS1000 AND
ADVANTECH™
ELECTRIC DRYERS
QUENCHER REPLACEMENT EMS1000 WASHERS PRIOR TO 1999 WITH WATER LEVEL SWITCH
IN THE CONSOLE
1. Unplug the washer from the AC outlet.
2. Remove the screws from the front bottom of the console and rotate the console up into the service position.
3. Disconnect the violet wire with the white stripe from the pressure switch.
4. Connect either quencher wire into the pressure switch where the violet wire with the white stripe was removed.
5. Reconnect the violet wire with the white stripe to the piggyback connector on the quencher wire.
6. Disconnect the pink wire from the pressure switch.
SUPRESSOR QUENCHER APPLICATION TABLE
SUPRESSOR LINE IN, PART NUMBER
AND LOCATION
3951390 Located between power cord
plug and wiring harness plug
3406196 Located in the console behind
the power cord access panel
3406197 Located at the black and white
harness plug near the power cord
terminal block
PART NUMBER AND LOCATION
3952286 on water level switch in
console
1999 and after in harness near water
level switch connection, harness must
be replaced if quencher fails
located in the wiring harness near the
gas valve, harness must be replaced if
quencher fails
— 2 —
QUENCHER
(continued)

Publicidad

loading

Este manual también es adecuado para:

Cae2762kq0Cae2792kq0Cee2760kq0Cee2790kq0Cep2760kq0Csp2770kq0 ... Mostrar todo