GYS DRAW ALIGNER PRO Manual Del Usuario página 15

Operating manual
APPLICATION
Firstly, rings must be welded or glued to the bodywork to allow the double claw foot
chain to be attached. Pass a rod through the rings to allow the chain to be pulled
through. The bracket can be positioned in two different ways on the vehicle to allow
for easy pulling:
If the vehicle has a lip under the chassis, use the metal piece shown opposite
to rest against the lip and lock the bracket in place during pulling. To do this,
turn the crank on the back of the drawer aligner.
If the area to be straightened is near a wheel, you can use the plate by
positioning the vehicle's wheel on the plate. The plate swivels to position itself
in the desired pull direction. If necessary, you can add a support using the
telescopic extensions.
The PRO PULLING BRACKET has a rotating pole to change the pull angle to
suit the pulling situation.
Translation of the original
instructions
DRAW ALIGNER PRO
15