TFK twinner twist duo Instrucciones De Uso página 10

- (fig. VII)
The backrest can be adjusted by pulling the two levers (14) and
regulation by the strap (15). So, the angle of the seat can be
adjusted stepless.
- (fig. VIII)
For the attachment of the belly frame (16), you open the material
rags at the covering and put the attachment over the crossbar. By
moving the locking levers (17) you can fix it. By pressing the red
buttons on the left and right side you can turn them into different
positions.
- (fig. IX)
By pressing the two adjusting hinges (18) the height of the push
bar can be adjusted.
- (fig. X)
The emergency brake (19) is running and parking brake at the same
time. In order to activate the parking brake, you must tighten the
brake lever (19) completely and turn the red park lever (20)
completely, so that the brake lever (19) remains maximally tightened
and the brake durably blocked. For release you must tighten the
brake lever (19) and unlock the park lever (20) again. If the braking
action diminishes, you can make a micro-adjustment. For that
purpose turn the adjusting screw (21) at the brake lever
contraclockwise and check the braking action.
- (fig. XI)
In order to fold the Twinner TWIST Duo together, you fold the foot rest,
release the two bolting devices (4) above the folding joint and the
double safety device (3) and swivel the push bar (2) forward. Press
behind the basket (1) until it unlocked and club it coaxial together.
Now you can fold the frame downwards (in front). Close the
transport lock at the frame, so that the Twinner TWIST Duo does not
open accidentally.
- (fig. XII)
If you are outside with the Twinner TWIST Duo, please fasten the
provided catch loop at the rear axle. Then you slip the elastic strip
over your wrist.