Application Overview - Danfoss ECflex 100T Guia De Instalacion

Installation Guide
6

Application overview

Cable type
ECflex 10T
ECflex 18T, ECflex 20T
ECflex 50T, ECflex 75T, ECflex 100T
ECfreeze 7,5T
ECsafe 20T
ECsafe 100T
ECsnow 20T
ECsnow 30T
ECsnow 300T
ECinfracable 75T, ECinfracable 100T
ECbasic 20S
ECasphalt 30T
ECasphalt 300T
ECaqua 9T
2) 3)
ECpipeheat 10 V2
1) 4)
SLPG , EChotwatt
1) 1)
ECiceguard, SLIG
1)
Heating cables/mats can be customized for the specific project, depending on voltage, required output, length of heating
1)
cable and length of cold leads.
Note: It is the full responsibility of the installer/designer to use proper cold lead dimensioned for the purpose and
assembly sets that establish sufficient mechanical strength, flammability resistance and water tightness - and to design
the heating unit with correct output for the specific application to avoid overheating of the cable or building materials.
The heating cable shall only be installed in concrete or used while fully covered with non-flamable material e.g. soil or
2)
similar.
The cable are approved for use in contact with drinking water or water for human consumption - comply to Danish GDV
3)
(Godkendt til drikkevand) demands.
The cable are not approved for installation inside the water pipe and for use in contact with drinking water or water for
4)
human consumption, waste water, etc.!
Regarding other types of applications please contact your local Danfoss sales company.
More information about applications can be found at www.danfoss.com
6
Heating cables
M2 x x x
M2 x
M2
M2 x
M2 x
M2
M2 x
M2
M2
M2
C x
M2
M2
M1 x
M2 x
M2 x
M2 x
Applications
x x x
x x x
x x
x x
x x x x
x
x x x
x
x
x x x
x x
x x x
x x x
x x
x
x x
x x
x