Care And Cleaning - Black and Decker TCM850 Manual Del Usuario

TCM850Pub1000001038 5/10/04 2:55 PM Page 6
F
G
5. Thermal carafe keeps coffee hot for up to four hours.
SETTING THE CLOCK (H)
1. Plug in the coffeemaker.
2. Press the HOURS and MINUTES buttons to the current time. A small light at the top left of
the clock display indicates P.M.
Note: Unplugging the unit will reset the clock/timer to12:00.
H
1. Press and hold the PROGRAM button for 1 second. Green light flashes and the clock
display changes to show current programmed time or default of 12:00.
2. Press the HOURS and MINUTES buttons until the desired brew time is reached.
Note: If you wait more than 3 seconds to program brew time, or if the green light stops
flashing, the clock redisplays the current time of day. You must then repeat the above steps
to program.
3. Once programmed to the desired time, press the AUTO-ON button.
4. Programmed brewing time momentarily displays and the green AUTO-ON light
illuminates indicating that the coffeemaker is preset for automatic brewing. If AUTO-ON
light is not lit, automatic brewing function is not properly set.
5. When brewing begins the red "On" light illuminates.
J

Care and Cleaning

Caution: Do not overexpose the control pad to water. It is not waterproof. Water may cause
permanent damage and make coffeemaker inoperable.
CLEANING
1. Be sure the unit is unplugged and cooled.
2. Press latch to open brew chamber.
All manuals and user guides at all-guides.com
THERMAL CARAFE
1. Coffee is brewed directly into carafe via closed brew thru lid.
Lock lid by aligning LOCK arrowhead with arrowhead on carafe
rim. Coffee may overflow if the lid is not properly
in place.
2. Carafe keeps coffee hot and may be left away from coffeemaker
for serving. Be sure the pour button is in the up position to seal
in heat and flavor.
3. To pour, push down on the pour button. Be sure that lid and
carafe rim arrowheads are aligned (G).
Caution: Do not pour liquid from the carafe until lid is securely
closed.
4. When finished pouring, push down on the pour button again
and button pops up.
PROGRAMMING THE TIMER FOR AUTO-BREW (H)
If the clock is not set for the current time of day, see "Setting the
Clock" section.
To preset your coffeemaker to begin brewing at a certain time, first
follow steps 1-11 in the "BREWING A POT OF COFFEE" section.
6. Be sure carafe is properly placed into coffeemaker or coffee will
not brew (J).
Note: The Auto-Brew function can be cancelled at any time by
pressing the AUTO-ON button a second time. The AUTO-ON light
will go out.
5
3. Use filter basket handle to lift filter ba
4. Discard the paper filter with the grou
5. The filter basket and lid are top-rack
warm, sudsy water.
6. Wipe the interior of the brew chamb
a soft damp cloth. Do not use abrasiv
coffeemaker in water.
7. Place cleaned filter basket into clean
8. To clean th
reservoir, w
to air dry.
STORING
Power cord tu
Maintaining Y
K
Mineral depos
1. Lift water re
white vineg
on the wate
2. Press latch
3. Be sure the
4. Insert paper
L
closed.
5. Place the c
coffeemake
plug in the
6. Press the O
7. Let half of t
M
solution lev
ON/OFF button again to turn off the cof
soften mineral deposits.
8. Press the ON/OFF button to turn th
solution into the carafe.
9. When the vinegar solution has finis
the carafe and rinse with clean wat
10. Refill the water reservoir with cold
another brew cycle to rinse out any
11. Wash the water reservoir, filter bask