Care And Cleaning - Black and Decker Cafe Noi DCM1400 Manual Del Usuario

DCM1400Pub178998RV1 8/9/05
1. Turn unit off.
2. Wait 10 minutes to prevent hot water in tubes from splashing out.
3. Follow instructions in "BREWING COFFEE".
SNEAK-A-CUP® INTERRUPT FEATURE
You can pour a cup of coffee while coffee is brewing without leaking from the brew
basket.
When finished pouring coffee, place the carafe under brew basket (C). The brewing
C
D
set.
3. Press the AUTO button. The auto light illuminates, indicating the timer is activated.
4. To check your preset auto brewing time, press PROG and view display. When you
release the PROG button, the clock displays the current time of day.
5. To automatically repeat brewing at the same preset auto-on time, prepare your
coffeemaker for brewing again and press the AUTO button. The AUTO light illuminates.
Note: The auto-brew function can be cancelled at any time by pressing the OFF button.
The AUTO light goes out.

Care and Cleaning

CLEANING YOUR COFFEEMAKER
This product contains no user serviceable parts. Refer service to qualified service
personnel.
Caution: The control panel is not waterproof. Do not overexpose the control panel to
water. Water may cause permanent damage and make the coffeemaker inoperable.
CLEANING
1. Be sure the unit is unplugged and cooled.
2. Remove the filter holder by lifting the basket straight up.
3. Discard the paper filter with the grounds.
4. Clean parts as follows:
• Filter holder, carafe and lid are all top rack dishwasher safe; or they may be hand
washed in warm, sudsy water.
• Wipe the exterior and the "Keep Hot" plate with a soft damp cloth. Do not use abrasive
cleansers or scouring pads. Never immerse the coffeemaker in water.
12:40 PM Page 6
All manuals and user guides at all-guides.com
process continues.
Important: To avoid possible overflow after removing the carafe,
be sure to replace the carafe under the brew basket within one
minute or less.
Programming the Coffeemaker for Auto Brew (D)
Be sure clock is set for the current time of day see "SETTING
THE CLOCK."
1. To preset the coffeemaker to begin brewing at a certain time
first follow steps (1-9) in "BREWING COFFEE."
2. To program the coffeemaker for Auto Brew:
a. Press and continue to hold down the PROG button with
one finger while you press the HOUR, then MIN buttons
until desired brew time is reached. Be sure to watch for the
P.M. indicator in the digital display.
b. When you let go of the PROG button, the auto time is
5
• To clean in
allowing it
from under
place wate
5. Insert filter
CARING FOR
A damaged ca
E
To avoid brea
• Do not allow all liquid to evaporate
heat the carafe when empty.
• Discard the carafe if damaged in an
• Never use abrasive scouring pads o
• Do not place the carafe on or near
a microwave oven.
• Avoid rough handling and sharp blo
MINERAL DEPOSITS AND CLOGGING
Mineral deposits left by hard water can
prolonged brewing cycle are signs that
every 3 months.
1. Pour white vinegar into the water re
Add fresh water up to the 6-cup line
2. Press brew basket release button to
3. Put a new paper filter in the brew b
Set the empty carafe on the "Keep H
4. Turn the coffeemaker on and let hal
the coffeemaker off and let it soak fo
5. Turn the coffeemaker on and brew
6. When the cleaning solution has fini
carafe and rinse with clean water.
7. Refill the reservoir with cold water t
paper filter in the brew basket, then
cycle to flush out the remaining cle
8. Wash the brew basket and carafe an