Stanley FATMAX FMHT77165 Manual Del Usuario página 7

3. Press Gear Icon (Figure A
show Volume on the display window
4
(Figure F ).
4. Measure the width.
• Point the top of the tool at one side of the
target (room or object).
• Position the bottom of the tool at one end
of the target and point the laser dot across
the width (Figure H
• Press On to display the width
measurement at the top of the display
window.
5. Measure the length.
• Position the bottom of the tool at one end
of the target and point the laser dot across
the length (Figure (H
• Press On to display the length
measurement on the second line of the
display window.
6. Measure the height.
• Positon the bottom of the tool at one end
of the target and point the laser dot across
the height (Figure H
• Press On to take the measurement.
7. View the Volume measurement at the
bottom of the display window (Figure
3
F ).
Measuring the Height of a Tall Object
If you need to measure the height of a tall
object (e.g., a tall building), you can calculate
the height based on the distances from the
same point to 2 or 3 points on the object.
The tool will use the Pythagorean Theorem
(C2=A2+B2) to calculate the height.
Distances to 2 Points
You can use the distance to two points on
a tall object (Double Indirect Height) to
determine its height (Figure I
1. Point the tool's laser (Figure A
a wall or object, and not toward anyone's
eyes.
2. Press On (Figure A
and display the red laser dot.
4
) twice to
1
).
2
).
3
).
1
).
1
) toward
3
) to turn the tool on
3. Press Gear Icon (Figure A
to show on the display window
4
(Figure F ).
4. Position the tool opposite the bottom of
the building or object whose height you
need to measure (Figure I
5. Aim the laser at the highest point of the
building or object (Figure I
6. Press On to measure the distance.
7. From the same point, aim the laser
straight ahead toward the lowest point of
the building or object (Figure I
8. Press On to measure the distance.
9. On the bottom line of the screen, view the
height of the building or object.
Distances to 3 Points
1. You can use the distance to three points
on a tall object to determine its height
1
(Figure J ).
2. Point the tool's laser (Figure A
a wall or object, and not toward anyone's
eyes.
3. Press On (Figure A
and display the red laser dot.
4. Press Gear Icon (Figure A
show on the display window (Figure
4
F ).
5. Position the tool opposite the
approximate center of the vertical height
to be measured (Figure J
6. Aim the laser at the highest point of the
building or object (Figure J)
7. Press On to measure the distance.
8. From the same point, aim the laser
straight ahead toward the center of the
building or object (Figure J
9. Press On to measure the distance.
10. From the same point, aim the laser at
the lowest point of the building or object
4
(Figure J ).Press On to measure the
distance.
4
) three times
2
).
3
).
3
).
1
) toward
3
) to turn the tool on
4
) our times to
2
).
2
).
3
) .
E
7