Domo DO910K Manual De Instrucciones página 43

www.domo-elektro.be
INSTALLATION
Caution:
• Unpack the appliance and check whether the appliance has suffered any damages.
Do not connect the appliance to the power net if it is damaged.
• It is recommended to wait 4 hours before connecting the appliance to a socket, so
that the oil can flow back to the compressor.
• There should be adequate air circulation around the appliance, so that it does not
overheat.
• Do not place the appliance too close to a radiator or stove.
• Make sure that after installation, you still have access to the power plug.
• Place the appliance in an area with an ambient temperature between 16°C and
32°C.
1. Screw the spacers onto the connections
at the back of the appliance.
2. Make sure that there is enough room
to swing open te door. Leave a space
of at least 5 cm at both sides of the
appliance. Leave a space of at least 10
cm between the top of the appliance and
any overhanging wall units. Caution:
it is better not to have any overhanging wall units above the
appliance.
3. Make sure that the appliance stands up straight. Use the
levelling feet at the bottom of the appliance to adjust.
BEFORE THE FIRST USE
Clean the inside of the appliance and all the accessories with lukewarm water and
some neutral soap. Dry thoroughly before using the appliance for the first time.
Do not use any detergents or abrasive powders as they may damage the finish.
USE
Caution:
• Do not place any hot objects onto the plastic parts of the appliance.
• Do not place anything directly against the rear wall inside the appliance.
• Frozen foods should not be frozen again once they have been thawed.
• Do not place any sparkling or fizzy drinks inside the freezer. This causes pressure
and may cause the container to explode.
Temperature setting
Plug in the appliance. The temperature can be set with the
thermostat knob. There are 8 settings. 1 is the warmest setting, 7
is the coldest. When it is set to 0, the appliance is switched off.
43
DO910K