Important Considerations - Kalor SLIM IDRO 16 Manual Del Usuario

Per il tecnico specializzato:
To con gure the hydraulic diagram, press the SET key and then
settings" menu with the power key. PPress the SET key again to enter the menu and enter the
access key in possession of only the technician authorized by the manufacturer. Con rm the access key in possession of only the technician authorized by the manufacturer. Con rm the
password using the set key and the key password using the set key and the key password using the set key and the key
Con rm with the SET key and use the
number.
For end user:
It is possible to change the thermostove operating principle according to the season by choosing
between summer and winter. To select the season press SET, the season selection will appear on
the display. Then press the set key again and select the season with keys 1 and 2. Once selected,
press the ON / OFF key to exit.
The choice of season changes the thermostove operation, see next chapter.
Following the principles of operation of the various hydraulic diagrams.

Important considerations:

• Healthcare will always have priority
• There are three types of stand-by:
Type 01: the ambient temperature detected by the probe on the board has reached the SET
AIR set
Type 02: the water temperature in the thermostove has reached the SET H2O set
Type 03: the external thermostat has detected that the desired temperature has been reached
and therefore the contact is open.
In this speci c case the thermostove behaves as follows:
If the thermostat carries voltage to the card causing faults, the warranty will expire.
To con gure the thermostat, simply remove the jumper on the THERM terminal (see the tab on
page 16) and connect our room thermostat, OPERATION BY A SPECIALIZED TECHNICIAN.
How to select the type of Stand-by (OPERATION BY A SPECIALIZED TECHNICIAN):
Press the SET button; press button
access key and con rm it by pressing the SET key again. Press the
The display will show the different stand-by modes mentioned above, choose the mode using the The display will show the different stand-by modes mentioned above, choose the mode using the The display will show the different stand-by modes mentioned above, choose the mode using the The display will show the different stand-by modes mentioned above, choose the mode using the The display will show the different stand-by modes mentioned above, choose the mode using the The display will show the different stand-by modes mentioned above, choose the mode using the
and keys.
NOTE: The hydraulic scheme 00 is set by default, the WINTER season with stand-by mode 02.
When the stove is switched off manually or by programming, automatic ignitions exit from a stand-
by state will not be possible.
How to enable or disable the stand-by mode:
Press the SET button. With the
sto select whether to enable (ON) or disable (OFF) the thermostove stand-by function. sto select whether to enable (ON) or disable (OFF) the thermostove stand-by function.
Press the ON / OFF button to exit
Let's see speci cally the behavior of the thermostove according to the hydraulic scheme, the
presence and the stand-by mode and the chosen season.
of the power go to menu 3 "hydraulic scheme". of the power go to menu 3 "hydraulic scheme". of the power go to menu 3 "hydraulic scheme".
and keys to select the required hydraulic scheme
to go to menu 09. Press the SET button again. Enter the to go to menu 09. Press the SET button again. Enter the to go to menu 09. Press the SET button again. Enter the
, key, go to menu 05 and con rm with the SET key. Use key
.
scroll to the "Technical
key to go to menu 9-5.
73