BGS technic 8515 Instruction Manual página 5

WARNING
Study, understand, and follow all instructions provided before attempting to use this equipment.
•
Do not exceed rated capacity.
•
Do not exceed maximum width.
•
Never crawl under the suspended load for any reason.
•
Ensure that the engine is supported securely before repairing.
•
Do not use this device for any purpose other than that for which it is intended.
•
No alterations shall be made to this product.
•
Failure to heed these markings may result in personal injury and/or property damage.
ASSEMBLY
1. Insert the wide leg (#13) into tube welded at the end of boom (#1) and the narrow leg (#14) to
boom extension (#2).
2. Slide transfer adapter (#11) over the end of boom extension (#2) with tube toward you.
3. Insert the boom extension (#2) into boom (#1). NOTE: The Engine Transverse Bar may be used
with or without support arm, depending on the load being supported.
4. To use without support arm: Secure both threaded hooks (#3) to the tube welded on boom and
transfer adapter with barrel hex. nut (#7). Thread the hex. nut (#7) all the way down towards the
hook portion to hold it out of the way until needed.
5. To use with support arm:
(a) Insert the adjustable leg (#6) to support arm (#10), then hand tight with M8x65 bolt and wing
nut (#9 & 8). Do not fully tighten wing nut as height adjustment may be necessary once the
Engine Transverse Bar is placed over the engine compartment of the vehicle.
(b) After determining the length of support arm needed, connect the support arm (#10) to transfer
adapter (#11) on the boom extension with M12x120 bolt and wing nut (#5 & 4). Again, do not
fully tighten as some length adjustment may be required.
(c) Before placing the Engine Transverse Bar over the engine compartment, install the two
threaded hooks (#3) povided. Insert one hook to the tube welded on boom (#1) and secure
with barrel hex. nut (#7). Thread the hex. nut (#7) all the way down towards the hook portion to
hold it out of the way until needed. Then, locate the best position on the support arm for the
second hook and install in the same manner.
6. Now the Engine Transverse Bar is ready to use.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Boom
A
Extension
Threaded
B
Hooks
C Boom
D Boom Leg
E Support Arm
F Adjustable Leg
G Cable
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed