SPIT Spitfire P370 Manual De Instrucciones página 15

Choosing the charge
(see fig. 6)
Choosing the strength
(see fig. 7)
Removing the charger
disc
Notice 010_GB.indd
Using the tool
- 031740 brown 6.3/10 disc charge - very light
- 031600 green 6.3/10 disc charge - light
- 031700 yellow 6.3/10 disc charge - medium
- 011658 red 6.3/10 disc charge - heavy
Tips :

Choose according to :
• the nature and hardness of the support material
• the length of the stud
• the nature of the part to be fixed
Proceed by successive trials, beginning with the lightest strength,
then increase if necessary.
If the charge has misfired, wait for 20 seconds,
keeping the tool on the work surface, then stop
pressing in order to reset the percussion system and
to resume firing.
Unlock the cover

Remove the disc

The tool must always be emptied after use and
before storage in the box. Partially used charger
discs must be kept for later use.
Checking the wear parts
The tool is equipped with a rubber spring (3) (for the return of

the inertia block), an inertia block + insulation ring assembly (2)
(see fig. 8).
These parts must be checked at regular intervals

Wear part
Spring (3)
Insulation ring
+
inertia block (2)
15
Check
- length (min. 161 mm)
- Condition (cuts, wear, etc.)
- Thickness (mini 4 mm)
- Condition (cuts, wear, etc.)
- No chipped part on the inertia block
26/02/04, 7:52
GB
15