Duronic FN30 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
1.
Unfasten the connecting screw (part 15) from the support tube (12) and
insert the support tube (12) into the base (14).
2.
Tighten the connecting screw (15) into the bottom of the base to secure the
support tube (12) in place.
3.
Unscrew the blade fastener (4) and cover fastener (2) from the fan motor head.
4.
Separate the back cover (1) from the blade (3) by unfastening the screw.
Attach the back cover (1) to the fan motor head and fasten in place with the cover
5.
fastener (2).
Attach the blade (3) to the output shaft (7) and fasten in place with the blade fastener (4).
6.
7.
Attach the front cover (5) onto the back cover (1) and secure it in place using
the plastic ring (6) and tighten it in place
8. Lastly, place the assembled fan head onto the extension tube (10) and fix in place
using the tightening screw on the back.
1.
Adjustment of the wind direction
The angle of the fan head is adjustable upwards or downwards by slightly lifting
or pressing the mesh cover.
2.
Adjustment of the rotation/oscillation
Pressing the oscillation lock on the top of the motor head will activate the rotation function.
Pull the button up again to stock the fan head oscillating.
3.
Adjustment of the wind speed
This fan has 3 speed settings which can be selected by pressing the numbered buttons on
the control panel. Choose from speed 1, 2 and 3.
How to Set Up Your Fan
How to Use the FN30
with the screw.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido