Duronic FFPS Manual De Instrucciones página 9

9) Insert this into the top of the screen and push all the
way through so that the rod appears at the other end.
Repeat this for the bottom part of the screen, joining
the remaining two single-ended rods together and
pushing it through the bottom part of the screen.
Then insert the two shorter double-ended rods into the
sides of the screen.
11) Place the screen material onto the frame. Starting
from one end of the screen, start to push the tension
pegs through the pre-made holes along the edge of the
screen fabric. Work your way along the screen until all
of the tension pegs are in their corresponding holes.
Note:
• The last few tension pegs may require firm
pulling in order to keep the screen perfectly
flat.
• The red arrows are for a guide only, the
tension pegs do not need to align perfectly with
these when the screen is fitted.
Check that everything looks correct before continuing.
12) Place the support bar in the middle of the screen diagonally.
Ensuring the ends of the support bar tuck underneath the back of the frame,
slowly push the bar until it is vertical in the centre of the screen where the
frame pieces join.
9