Replacing The Remote Control Batteries; Technical Specification - Duronic FN65 Manual De Instrucciones

4. Fixing the pole to the Fan Head
The fan head should now all be assembled and
attached to the control box. Next, loosen the
control box locknut (12) and place the whole
assembled fan head with control box onto the
inner tube (15) and fasten in place by tightening
the control box locknut (12).

Replacing the Remote Control Batteries

1. Open the battery cover on the back of the remote.
2. Remove the old battery and dispose of it responsibly.
3. Insert the new battery (ensure that the positive and negative side of the
battery are in the correct place).
4. Close the battery cover.

Technical Specification

Model Voltage Frequency Power
FN65 220V 50Hz 60W
8