Cleaning, Care & Maintenance; Troubleshooting - NISBETS ESSENTIALS HE153 Manual De Instrucciones

Lock/Unlock the Pump Button
• Slide the lock to the CLOSED position to lock the pump button (
• Slide the lock to the OPEN position to unlock the pump button (
Lock/Unlock the control panel
To lock/unlock the control panel, press the Lock/Unlock button.
Cleaning, Care & Maintenance
Always disconnect the appliance from the power supply and let it cool down before cleaning
and maintenance.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
• NEVER immerse the appliance in water.
De-scaling
For the best water quality,
supply, particularly in hard water areas. Doing so will reduce the build up of limescale and contaminants in the
water tank thus maintaining energy efficiency and prolonging the life of the appliance.
To de-scale the appliance:
• Fill the inner pot with water and lemon juice (or a suitable de-scaler), and boil.
• Discard the solution. Note: Always run water through the appliance after descaling to rinse the inner
pot and tubes.
Note: Use a suitable de-scaler and always follow the instructions on the packaging.
Nisbets Essentials recommend that this appliance is de-scaled every 3 months or more frequently in
hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.

Troubleshooting

Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Steam leaks from Seal worn
the silicon seal
No water is Seal deformed or lost pliancy
pumped out
When the water just gets
boiled, there is too much steam
accumulated inside the pot
Unit stops working No water inside so boil dry
suddenly, "Empty" protection is activated
indicator on
HE153_ML_A5_v1_20211014.indb 5 HE153_ML_A5_v1_20211014.indb 5
recommend that a water filter is installed to the mains water
Nisbets Essentials
Probable Cause
Check the unit is plugged in correctly and switched on
Call Nisbets Essentials agent or qualified technician
Replace the plug fuse
Check power supply
Call Nisbets Essentials agent or qualified technician
Call Nisbets Essentials agent or qualified technician to
have the silicon seal replaced
Once temperature has been reached, please allow several
seconds for the pressures to equalise prior to activating
the pump
Allow to cool thoroughly before re-filling
position).
position).
Solution
UK
5
2021/10/14 13:17 2021/10/14 13:17