Beper 40.450GO Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
EN
Hair straightener Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Product description Fig. A
1. Plates with ceramic coating
2. Temperature control from 130° to 230°C
3. Hanging hook
4. 360° rotating cable
5. ON/OFF switch button
6. Plate lock /unlock button
Operation
Fully unroll the power cord.
Connect the appliance to a suitable power outlet.
Open the plates using the appropriate release button.
Switch on the appliance and set the desired temperature, wait 3 to 5 minutes before using it.
Warning: Do not hold hair between the plates for longer than two seconds
To make sure you get the results you want, you at first should always experiment on a small area of hair.
Dry previously washed hair with a hairdryer, untangling it with a wide-toothed comb.
Separate the hair into strands of about 3 cm.
Then proceed as follows:
Curling your hair
Create natural curls, turned under
Take up a section of hair and place the straightener at the roots with the curved plates facing the scalp. (Fig.B1)
Turn the straightener 90° downwards so that the curved plates face outwards. (Fig.B2)
You can hold the stay-cool tip with your other hand so that it is easier to handle the straightener and maintain an
even pressure on the section. (Fig. B3)
Slowly slide the straightener down the whole length of the section, from the roots to the tips. (Fig. B4 and B5)
They are the curved plates that give the effect and fix the curl.
Remove the straightener and use your fingers to twist the section again so that it takes its natural position. (Fig.
B6)
Repeat if necessary.
You may wish to set the curls using a light misting of hairspray.
Create more sophisticated pointing out curls
Take up a section and place the straightener at the roots with the curved plates facing your scalp. (Fig.B7)
Turn the straightener 90° upwards so that the curved plates now point outwards. (Fig.B8)
You can use your other hand to hold the stay-cool tip to make handling the straightener easier and to maintain
an even pressure on the section. (Fig.B9)
Slowly glide the straightener over the length of the section, from the roots to the tips. (Fig.B10 e B11)
The more even and the slower the stroke, the more marked the curl!
7

Publicidad

Tabla de contenido
loading

Tabla de contenido