Tube Suspension - BROMIC PLATINUM SMART-HEAT Instalacion, Instrucciones Y Manual

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

HEATING INSTALLATION INSTRUCTIONS
TUBE SUSPENSION (SOLD SEPARATELY)
1. Heater must be installed with heater surface at least
2400mm above the floor level.
Supplied suspension tubes position heater surface
1000mm below the ceiling surface.
If required, cut down length of suspension tubes to
ensure correct installation height.
Minimum distance from front surface of heater to
ceiling surface must be 180mm.
Minimum distance between heaters measured from
edge of heaters must be at least 500mm.
2. If suspension tubes are cut down, drill new mounting
holes in each tube.
3. Feed power cord through hole in rear bracket and
suspension tube.
4. Attach rear bracket to heater with M5 screws.
5. Assemble suspension tubes to rear bracket with M5
screw and nut.
6. Rotate heater to required angle. 15° or 30° in either
direction. Lock into position with M3 screw and nut.
7. Slide ceiling bracket cover over suspension tubes.
8. Assemble supplied rubber grommets in ceiling bracket
to protect power supply cables.
9. Bring ceiling bracket to suspension tubes & feed
power cord through required hole in ceiling
bracket supports. Note: Which hole to feed
power cord through is defined by where the power
is brough into the ceiling bracket in Step 12.
Locate suspension tubes inside ceiling bracket supports.
10. M5 bolts through ceiling bracket supports &suspension
tubes. Secure with nyloc nuts.
11. Raise heater assembly into position. Attach ceiling
bracket to surface through mounting holes with
appropriate fasteners (Not supplied).
12. Bring power into ceiling bracket through ceiling
access holes or side access holes. Use minimum
IP55 rated cable gland in the Ø16mm holes.
If side access holes are not used, assemble supplied
hole plugs.
13. Make electrical connection from suspension tube power
cord to power from ceiling.
14. Slide ceiling bracket cover up suspension tubes into
position. Secure with self tapping screws.
12
All manuals and user guides at all-guides.com
13
www.bromicheating.com
CONTINUED...
600
960
3
8
11
9
10
14
1
20
Suspension Tube
2
Mounting Hole
6
5
4
12
7

Publicidad

Tabla de contenido
loading

Productos relacionados para BROMIC PLATINUM SMART-HEAT

Este manual también es adecuado para:

Bh0320001

Tabla de contenido