Chain Suspension - BROMIC PLATINUM SMART-HEAT Instalacion, Instrucciones Y Manual

HEATING INSTALLATION INSTRUCTIONS
CHAIN SUSPENSION (SOLD SEPARATELY)
1. Heater must be installed with heater surface at least
2400mm above the floor level. If required, cut down
length of chain to ensure correct installation height.
Minimum distance between heaters measured from
edge of heaters must be at least 500mm.
Minimum distance from front surface of heater to
ceiling surface must be at least 180mm.
2. Feed power cord through hole in rear bracket.
3. Attach rear bracket to heater with M5x10 screws.
4. Attach chains to heater with "S" hooks. Crimp "S"
hooks closed after assembly.
5. Prepare ceiling structure for heater. Attach chains to
ceiling structure & suspend heater.
6. Fix heater power cord to ceiling chain with cable ties.
7. Make electrical connection from heater to power
supply.
All manuals and user guides at all-guides.com
2
www.bromicheating.com
CONTINUED...
417
960
3
7
6
1
4
5
13