Installation Requirements - Whirlpool WHAD303AW Manual De Uso Y Cuidado

INSTALLATION REQUIREMENTS

Electrical Requirements—All Models
The electrical ratings for your dehumidifier are listed on the model
and serial number label. The model and serial number label is
located on the right-hand side of the dehumidifier cabinet.
Electrical Requirements
115 Volts (103.5 min.-126.5 max.)
■
0-12 amps
■
15-amp time-delay fuse or circuit-breaker
■
If there is a "Single Circuit Only" label on the unit, use on a
■
dedicated single-outlet circuit only. If a dedicated single-outlet
circuit is not available, then it is the customer's responsibility
to have a single-outlet circuit installed by a qualified
electrician.
If there is no "Single Circuit Only" label on the
■
unit, the unit may be used on any branch circuit
of correct voltage and adequate current
protection rating.
Recommended Grounding Method
This dehumidifier must be grounded. This dehumidifier is
equipped with a power supply cord having a grounded 3-prong
plug. To minimize possible shock hazard, the cord must be
plugged into a mating, grounded 3-prong outlet, grounded in
accordance with all local codes and ordinances. If a mating outlet
is not available, it is the customer's responsibility to have
a properly grounded 3-prong outlet installed by a qualified
electrical installer. It is the customer's responsibility:
to contact a qualified electrical installer.
■
to assure that the electrical installation is adequate and in
■
conformance with National Electrical Code, ANSI/NFPA
70 - latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
Installation Instructions
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dehumidifier.
Failure to do so can result in back or other injury.
Remove Packaging Materials:
Handle the dehumidifier gently while unpacking the unit.
■
Remove the carton top and lift the dehumidifier from the base
■
pad.
Remove tape and glue residue from surfaces before turning
■
on the dehumidifier. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with a damp cloth
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your dehumidifier.
Dispose of/recycle packaging materials in an appropriate way.
■
3