Axxess GMOS-MOST-01 Instrucciones De Instalación página 3

DIN jack:
Disregard the DIN jack, it will not be used in this application.
Note: The relay attached to the GMOS-MOST-01 harness is only for audible turn signal clicks. No
extra steps are required to retain this feature, so leave the relay as-is.
From the backup camera harness:
To the aftermarket radio:
• Connect the Yellow RCA jack to the BACKUP CAMERA input.
To the vehicle:
• Connect the backup camera harness, to the male Gray connector removed from the Human
Machine Interface module (HMI). (Figure B)
For the Chevy Colorado and GMC Canyon:
• The HMI module is located in the radio cavity, down low.
For all other models:
• The HMI module is located behind the glove box. There are (2) modules behind the glove
box. The HMI module is behind the metal dashboard support. (Figure C)
• Drop the glove box down by first removing the retaining cable on the right side. Then
squeeze the glove box sides and gently pull down.
• Remove (6) T-15 Torx screws securing the plastic panel now exposed.
All manuals and user guides at all-guides.com
CONNECTIONS
From the 10-pin or 12-pin jumper harness to the vehicle:
(CONT)
Human Machine Interface module
(Figure B)
If the vehicle does not have a CD or DVD-Drive, disregard these steps.
For models without rear seat entertainment:
• Connect the female Black 10-pin jumper harness, to the male Black 10-pin harness
removed from the CD-Drive.
For models with rear seat entertainment:
• Connect the female Black 12-pin jumper harness, to the male Black 12-pin harness
removed from the DVD-Drive.
Note: Even though this step must be done for models with rear seat entertainment,
the rear seat entertainment system will not be retained by this interface.
(Arrow points to the location)
(Figure C)
REV. 9/28/2018 INSTGMOS-MOST-01
3