Makita FD01 Manual De Instrucciones página 7

OPERATION
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you.
Hold the tool firmly with one hand on the grip and the
other hand on the bottom of the battery cartridge to
control the twisting action.
Screwdriving operation
008805
CAUTION:
Adjust the adjusting ring to the proper torque level
•
for your work.
Place the point of the driver bit in the screw head and
apply pressure to the tool. Start the tool slowly and then
increase the speed gradually. Release the switch trigger
as soon as the clutch cuts in.
CAUTION:
Make sure that the driver bit is inserted straight in
•
the screw head, or the screw and/or bit may be
damaged.
NOTE:
When driving wood screws, predrill pilot holes to
•
make driving easier and to prevent splitting of the
workpiece. See the chart.
Nominal diameter of wood screw Recommended size of pilot hole
(mm)
3.1 (1/8") 2.0 - 2.2 (5/64" - 3/32")
3.5 (9/64") 2.2 - 2.5 (3/32" - 3/32")
3.8 (5/32") 2.5 - 2.8 (3/32" - 7/64")
2.9 - 3.2 (7/64" - 1/8")
4.5 (11/64")
4.8 (3/16") 3.1 - 3.4 (1/8" - 9/64")
5.1 (13/64") 3.3 - 3.6 (1/8" - 9/64")
5.5 (7/32") 3.7 - 3.9 (9/64" - 5/32")
5.8 (7/32") 4.0 - 4.2 (5/32" - 11/64")
6.1 (15/64") 4.2 - 4.4 (11/64" - 11/64")
001904
All manuals and user guides at all-guides.com
Drilling operation
First, turn the adjusting ring so that the pointer points to
the marking. Then proceed as follows.
Drilling in wood
When drilling in wood, the best results are obtained with
wood drills equipped with a guide screw. The guide
screw makes drilling easier by pulling the bit into the
workpiece.
Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a center-punch and hammer
at the point to be drilled. Place the point of the bit in the
indentation and start drilling.
Use a cutting lubricant when drilling metals. The
exceptions are iron and brass which should be drilled
dry.
CAUTION:
Pressing excessively on the tool will not speed up
•
the drilling. In fact, this excessive pressure will
only serve to damage the tip of your bit, decrease
the tool performance and shorten the service life
of the tool.
There is a tremendous force exerted on the tool/bit
•
at the time of hole break through. Hold the tool
firmly and exert care when the bit begins to break
through the workpiece.
A stuck bit can be removed simply by setting the
•
reversing switch to reverse rotation in order to
back out. However, the tool may back out abruptly
if you do not hold it firmly.
Always secure small workpieces in a vise or
•
similar hold-down device.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Using the tool as a hand screwdriver
(mm)
008806
Switch off the tool.
Move the lock button to the locked position A.
Turn the tool.
NOTE:
This use
•
screwdriving.
7
is convenient for checking the