Before You Start - EDM Product 08783 Manual De Instrucciones

Fire hazard! Avoid short-circuiting the contacts of a
ES detached battery. Do not incinerate the battery
CHARGERS
• Never attempt to charge non-rechargeable batteries.
PT
• Have defective cords replaced immediately.
• Do not expose to water.
• Do not open the charger.
EN
• Do not probe the charger.
• The charger is intended for indoor use only.
FR

BEFORE YOU START

CHUCK
• Your tool has a 1/2" chuck
FORWARD/REVERSE SELECTOR(RIGHT/LEFT ROTATION
SELECTOR)
• Your tool has a forward/reverse selector located above the switch
trigger.
CAUTION: To prevent damage to the gearbox, always allow the chuck
to come to a complete stop before changing the direction of rotation. To
stop, release the trigger switch.
VARIABLE SPEED
• Your tool has a variable speed switch.
• The rotational speed and torque will in-/ decrease equivalently to
applied trigger pressure.
LED LIGHT
• Your tool is equipped with an LED light at the front.
TPR SOFT GRIP
• Your cordless drill is equipped with TPR soft grip and protective
parts. TPR (Thermoplastic rubber) is elastic, shock absorbing and
environmental friendly (recyclable).
OPERATION
CHARGING THE BATTERY PACK
The battery pack for this tool is supplied in a low charge condition to
prevent possible problems, therefore, you have to charge the battery
before first use.
Note: Batteries will not reach full charge the first time they are
charged. Allow several cycles for the item to fully charge. The
battery should only be charged indoors.
After normal use, about 1 hour of charging time is required for the 2.0Ah
battery to be fully charged. The battery pack will become slightly warm
while charging, this is normal and does not indicate a problem.
Instruction manual
Do not place the charger in an area of extreme heat or cold. Best is
at normal room temperature. When the battery becomes fully charged,
unplug your charger from the power supply and remove the battery pack
from the charger.
NOTE:
CHARGING INDICATION (FIG 1)
Connect the charger to the power outlet socket.
Note: If the battery does not fit properly, disconnect it and confirm that
the battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
BATTERY POWER INDICATOR (FIG 1A)
Those 3 LED might show the status of the capacity level of the battery:
INSERTING AND REMOVING THE BATTERY (FIG.2)
• Allow the battery pack to cool completely before charging.
• Inspect the battery pack before charging, do not charge a cracked
or leaking battery pack.
• Solid green: ready to charge
• Solid red: charging
• Solid green: charged
• Frequently monitor the charger and battery pack while connected.
• Unplug the charger and disconnect it from the battery pack when
finished.
• Allow the battery pack to cool completely before using it.
• Store the charger and battery pack indoors, out of reach of
children.
Note: If battery is hot after continuous use in the tool,
allow it to cool down to room temperature before charging.
This will extend the life of your batteries.
Note: Remove battery pack from charger stand which use
your thumb or fingers, press the battery's release button in
and pull the battery pack off at the same time.
• 3 LED's are lith: Battery fully charged
• 2 LED's are lith: Battery 60% charged
• 1 LED is lith: Battery almost discharged
Note: Remove battery pack from charger stand which use
your thumb or fingers, press the battery's release button in
and pull the battery pack off at the same time.
• Hold the tool with one hand and the battery pack (5) with the
other.
• To install: push and slide battery pack into battery port, make
08783
REF.