Charging Method - Metabo HPT UR 18DA Manual De Usuario

○ The radio has no charging function. Using the AC
adapter and rechargeable battery simultaneously
will not charge the battery.
If is displayed when you turn the power on
with the rechargeable battery inserted, the battery
power is low.
Power the radio from the AC adapter or insert a
charged battery.

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure
the following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second
intervals)
WARNING
Do not use the electrical
cord if damaged. Have it
repaired immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 7.
Pilot lamp
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1- second intervals.) (See
Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as shown
in Table 2, according to the condition of the battery
charger or the battery.
English
Battery
Guide rail
Fig. 7
13