Metabo HPT UR 18DA Manual De Usuario página 15

How to make the batteries perform longer
(1) Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its
battery. If you continue to use the tool and exhaust
the electric current, the battery may be damaged
and its life will become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery life will
be shortened. Leave the battery and recharge it
after it has cooled for a while.
CAUTION
● When the battery charger has been
continuously used, the battery charger will
be heated, thus constituting the cause of
the failures. Once the charging has been
completed, give 15 minutes rest until the next
charging.
● If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp
of the charger lights for 1 second, does not
light for 0.5 seconds (off for 0.5 seconds).
The battery will not be recharged. In such a
case, let the battery cool before charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector.
If there are no foreign objects, it is probable
that the battery or charger is malfunctioning.
Take it to your authorized Service Center.
USE
1. Switching On and Off
To switch on: Press button.
To switch off : Press button again.
2. Adjusting the volume
Increase volume: press "+" button.
Decrease volume: press "–" button.
3. Change between FM (ultra shortwave),
AM (medium wave) and Bluetooth (BT)
The set mode is shown in the display (FM / AM /
BT).
To change between FM (ultra shortwave / UKW),
AM (medium wave) and BT (Bluetooth), press the
"MODE" button several times.
4. Searching for radio stations
Press "│<<" button or ">>│" button to change the
frequency. The current frequency is shown on the
display.
To search the next radio station with high
signal strength, press the "│<<" button or press
the ">>│" button and keep pressed briefl y. The
frequency of the radio station found is shown on
the display.
5. Store set radio station
(1) Set the desired memory number by pressing
buttons "│<<" or ">>│".
(2) Press the "STATION" button for a long time.
The selected memory number blinks on the
display.
NOTE
The radio station can only be stored as long as the
number is blinking.
(3) Press the "STATION" button briefl y (store radio
station).
6. Listening to stored radio stations
Press "STATION" button briefl y until the desired
stored radio station is shown on the display and
played.
7. Bluetooth (depending on confi guration)
(1) To change to BT (Bluetooth), press the "MODE"
button several times, until BT shows on the
display.
(2) Activate Bluetooth on your smart phone
(or another mobile device such as a tablet).
(3) If your smart phone has detected the radio, it will
be shown with the device name "UR18DA".
(4) On your smart phone establish the connnection to
the device "UR18DA".
The successful connection is shown on the
display by pressing the symbol.
(5) Start replay e.g. of a song on your smart phone.
English
15