EHEIM vivaline LED Manual De Instrucciones página 15

English
5. Assembly
Location
‧ Avoid direct sunlight, and not too much daylight!
‧ Keep the aquarium away from heat sources.
‧ Keep the aquarium away from electrical equipment.
‧ Be aware of any nearby mains connections.
CAUTION! Material damage.
▶ Ensure that the surface is level and stable.
▶ Be mindful of the floor load provided by the entire weight.
Setting up and aligning the base cabinet (⌦A)
1. Place the base cabinet in the desired position.
2. Align the base cabinet horizontally using a spirit level.
A stand can be used for horizontal alignment. Ensure that the stand rests fully on the surface.
Setting up the aquarium (⌦B)
WARNING! Personal injury or material damage.
The aquarium must not be transported or carried when in its filled state.
CAUTION! Material damage.
No foreign bodies, mats or bases must be placed between the aquarium and base cabinet.
▶ Thoroughly clean the top side of the base cabinet and the lower side of the aquarium base.
▶ Remove any foreign bodies, mats or bases.
1. Place the empty aquarium incl. lower frame c on the base cabinet.
6. Commissioning
Installing the LED light
1. Lay the mains cable f along under the LED light d (⌦C).
2. Push the LED holder e approx. 2 – 3 cm over the LED light.
3. Turn the LED holder by 90° in a clockwise direction (⌦D).
4. Press the LED holder downwards until the LED light engages (⌦E).
5. Adapt the length of the LED light to your cover frame by moving the LED holder accordingly (⌦F).
6. Fasten the cable in the LED holder with the snap fittings (⌦G).
7. Set the LED light in the cover frame b. Ensure that the LED light is firmly seated (⌦H).
8. Feed the cable into the cover frame and through the rear opening to the outside.
For maintenance work, the LED light can be pushed into the cover frame (⌦H).
15