INSTALLATION
Strap Guide only
16mm (5/8")
5/32" (4mm)
ATTACH SHOULDER HARNESS
8mm (3/8")
Front-Pull
13 NM MAX
(115 lbf-in)
Rear-Pull
INSTALLATION REQUIREMENTS
Wheelchair with a solid backrest of metal or plastic,
up to 4mm (5/32") thick. Thicker backrests will re-
quire longer mounting screws with a minimum pullout
strength of 90kg (200lbs) (Not included in package).
POSITIONING
Seat user in wheelchair and establish correct posture
with pelvic support belt. Position strap guides
between neck and shoulder joint, approximately at
shoulder height (adjust up/down for pressure distri-
bution) Determine best strap guide orientation based
on the user's needs.
INSTALLATION
with Mounting Adapter
1. Attach strap guides to mounting adapter using
12mm (1/2") screws and nut plates.
2. Attach mounting adapter to the seat back using
the headrest receiver and its screws, or other
appropriate mounting hardware. (Not included in
package)
1
12mm (1/2")
5/32" (4mm)
Rear-Pull with 150mm
Strap Guide
2
13 NM MAX
(115 lbf-in)
Cam Buckle
en