Temple Touch PREMIUM Instrucciones De Uso página 4

For underarm measurement:
a. Place the thermometer probe in the center of the armpit as shown
(figure 7).
Gently press the thermometer's probe in an upward motion.
b. leave the patient's arm raised up until completed.
Correct placing and good contact with the skin ensure reliable
readouts.
7. As soon as the thermometer is in place, the measurement will
start automatically. A running circle will appear indicating that the
measurement is progressing successfully (Figure 8).
Make sure that the thermometer and the patient do not move while
measurement is in progress.
8. A temperature reading will be displayed within 6-8 seconds. One long beep will be
heard to indicate that measurement is complete and temperature will be displayed
for about 1 minute. The backlight will stay on until the device is shut down.
9. Press and release the Power button to turn the thermometer off, or it will shut off
automatically within 1 minute.
If you need to take another reading – wait 2 minutes after turning the
thermometer off and then begin again.
4. ROOM TEMPERATURE DISPLAY:
1. When the thermometer is OFF, continuously press the power button.
. The last body temperature will be displayed, and then will switch
to the room temperature. (see figure 9)
The room temperature will be displayed unless you press the
power button again and switch off the thermometer.
5. Using ODPT
The ODPT timer is designed to track the time elapsed between giving medicine
TM
dosages to patient and to act as an alert to parents as to when next medicine dosage
should be given (based on time cycle set by parent).
4
– Over Dose Protection Timer:
TM
7
8
9