Tabla de contenido
Publicidad
V. Installation :
1 ）Open the package and inspect whether the winder is damaged.
2）The winder must be installed in a work environment that meets the installation requirements.
3）Make sure the winder is properly installed according to the installation diagram below. Rivets or screws must be mounted in the
mounting holes of the bracket.
4）Once the hose reel series is installed, you can unscrew the screws on the stopper and move the stopper to the length of the wire
that needs to be exposed outside the equipment.
5）Opening the black cover at the side of the air inlet pipe, you can see the air pipe locking device as shown in the figure below. In the
factory, the ratchet tension spring is tightened at the "ON" position for locking the air pipe of any length as needed; and the ratchet
tension spring is tightened to the "OFF" position, so that the air pipe can move freely.
VI. Operation Instructions :
1 ）Check the equipment for abnormalities before use, and stop using it immediately if any. The equipment can be only used if it is
normal after repairing, otherwise a major accident may be caused. Please check whether the pipe is with damage, deformation, etc.,
otherwise injury to person or damage to equipment may be caused.
2）When using the winder, pull the air pipe with two hands slowly and evenly （with a force of about 3KG） to the appropriate length.
Stop pulling immediately when seeing the length warning mark, and lock it with the ratchet brake. Too high speed and excessive
pulling force may damage the product.
3）Avoid bending or stepping on the air pipe, and avoid contact with sharp objects during use.
4）Pull the tool out of the air pipe after use and wipe the air pipe clean.
All manuals and user guides at all-guides.com
98001/98002
Wall
中文
EN
DE
RU
KO
Ceiling
PT
JA
ES
9
Publicidad
Tabla de contenido
