Icons - Philips 2200 Serie Manual Del Usuario

Icons

Icon Explanation of signals
The Wi-Fi light is off
- The coffee machine is not connected to your home Wi-Fi (no initial Wi-Fi set-up
done so far).
- The machine's Wi-Fi connection is switched off.
- The home Wi-Fi connection is not working properly.
- The connection to your home Wi-Fi is lost e.g. because the home router has
changed or the network name or password has been changed.
- The distance between the coffee machine and router is too big.
The Wi-Fi light is on
The Wi-Fi setup has been completed successfully and the coffee machine is
connected to the home Wi-Fi.
The Wi-Fi light is flashing
- The coffee machine is in the setup mode during the Wi-Fi setup process. The
buttons on the coffee machine are inactive.
- In case the machine was already connected, the flashing light is an indication
that the coffee machine is in the process of reconnecting to the home Wi-Fi.
- In case the machine is connected to the Wi-Fi network, the slow flashing light is
an indication that the coffee machine is updating the firmware. This update can
take several minutes and during this time the coffee machine cannot be used.
The 'water tank empty'/'empty coffee grounds container' light is on.
- The water tank is almost empty. Fill the water tank with fresh water to the
maximum level indication.
- The water tank is not in place. Place back the water tank.
- The coffee grounds container is full. Remove and empty the coffee grounds
container while the machine is switched on. Wait at least 5 seconds before you
reinsert the container.
The alarm light is on
- The coffee grounds container and/or the drip tray is not in place or not placed
correctly. Place back the coffee grounds container and/or the drip tray and make
sure they are in the correct position.
- The service door is open. Remove the water tank and make sure the service door
is closed.
The alarm light is flashing
- The brew group is not in place or not placed correctly. Remove the brew group
and make sure it is locked into place. See chapter 'Removing and inserting the
brew group' for step-by-step instructions.
- The brew group is blocked. Remove the brew group and rinse it with water under
the tap. Then lubricate the brew group and place it back into the machine. See
chapter 'Cleaning and maintenance' for step-by-step instructions.
The alarm light is on and the start light flashes.
Some air is trapped inside the machine. To release the air from the machine, fill the
water tank with water, place a cup under the classic milk frother and press the
flashing start/stop button.
Be careful: small jets of hot water will be dispensed from the classic milk frother to
release the air.
English
23