Charging; Replacing Front And Back Grilles - Monster Clarity HD Micro Manual Del Usuario

Operation (continued)

CHARGING

Monster ® Micro comes with a lithium-ion battery
For best results, fully charge the Micro before use
To charge, connect the USB micro cable to the
power adapter Four sets of plug prongs are
included for worldwide use Connect appropriate
prongs to adapter and connect to USB cable
Monster Micro
To install plug prongs, slide the appropriate
prongs over the adapter until it clicks in the
locked position To remove plug prongs, press the
tab in the center of the plug prongs and slide up
Charging Indicator Lights
• Battery Low—Solid Red
• Battery Very Low—Flashing Red
• Battery Charging—Flashing Blue
• Fully Charged—LED Off (Power OFF),
Solid Blue (Power ON)
Caution
Battery is not user replaceable Danger of explosion
if battery is incorrectly replaced Batteries must be
recycled or disposed of properly
Install Plug Prongs:
1 2
Remove Plug Prongs:
1 2
REPLACING FRONT
AND BACK GRILLES
A selection of replacement grilles is available at
MonsterProducts com/products/clarityhdmicro
Both front and back grilles are attached to the
Micro with magnets To remove grille, pull up from
one end and the grille will detach Set replacement
grille on to the Micro and the magnets will pull it
into place
English
9