Monster SmartView 100S Guía Del Usuario Y Garantía página 14

Installing the Wall Plate
Masonry Mounting
Masonry mounting requires specialized knowledge, skills
and tools. Monster highly recommends that you seek the
help of a professional installer when mounting to masonry.
DO NOT drill holes in masonry mortar joints.
1) With the help of a friend, position the mounting plate
in the desired location.
�����
2)
�����
across the top of the mounting plate. Place the
provided level on the straight edge and confi rm that
the wall plate is plumb or vertically straight. Hold the
plate fi rmly in place.
3) Mark the centers of the top and bottom center
mounting holes with a pencil. Be careful not to mark a
mortar joint. With your electrical drill and 1/2" masonry
bit, pre-drill a 3" deep hole at each mark.
4) Install the supplied plastic anchors in each hole.
Tap into hole until fully seated.
5) Attach the wall plate to the wall using the lag bolts
and round washers as shown on the opposite page.
DO NOT over tighten bolts. This can damage
the wall plate or the surface of your wall.
10
All manuals and user guides at all-guides.com
Suspend a straight edge, such as a ruler,
continued