CRH HALFEN HTA Instrucciones De Montaje página 3

HALFEN HTA, HTA-CE, HZA, HZA DYNAGRIP
3. HALFEN Channels - short lengths and channels cut to length
3.1
≤200(250)mm ≤200(250)mm
25 mm
3.2
≥ 2 anchors!
≤200(250)mm
25 mm 25-35 mm
3.3
3.3.1
35 ≤ e ≤ 175(225) 
HALFEN ANK-E End
Anchor installed on-site
3.3.2
35 ≤ e ≤ 175(225)
3.3.3
M
Finished required length
End Anchor selection

Only one end anchor is permitted for
short channel length HZA 41/22.
Not included in Approval.
© 2019 HALFEN · INST_HTA 01/19 · www.halfen.com
≤200(250)mm
25
mm
≥ 2 anchors!
[mm]
D
HALFEN Channel
HTA 28/15
HTA 38/17
HTA 40/22
HTA 40/25
HZA 41/22 
3.1
A full range of ready to use short and standard
lengths are available from HALFEN.
3.2
HALFEN Channels can also be cut to length on
site. At least 25 - 35 mm of channel must remain
at both ends of the cut piece between each end
anchor and the respective channel end. HALFEN
Channels must have at least 2 anchors.
3.3
HALFEN Cast-in channels with site installed
end anchors
ANK-E End anchors are not included in
European Technical Assessment ETA-09/0339 and
ETA-16/0453.
ANK-E are not included with delivery of HALFEN
Channels. Please order these separately in the
same material and fi nish as the HALFEN Channel.
Cut the HALFEN Channel as required. The cut
3.3.1
must be at right angles to the channel-axis. Maxi-
mum and minimum lengths for "e" at the ends of
HALFEN Channels are 175/225  and 35 mm.
3.3.2
Select the type of ANK-E End anchor to fi t the
HALFEN Channel according to the table below.
Push the clamp on to the channel to its full extent;
press in the foam fi ller if necessary.
3.3.3
Tighten the hexagonal head bolt with a torque
wrench as specifi ed in the table below.

175 mm for profi le 28/15, 38/17; 225 mm for
profi le 40/22, 40/25 and 41/22
End anchor Thread
ANK - E1 M 8
ANK - E2 M 10
ANK - E2 M 10
ANK - E2 M 10
ANK - E2 M 10
Assembly Instructions
Torque T [Nm]
inst
10
20
20
20
20
3