Power Supply - Stanley HL2PKS Manual De Instruccion

• Carefully follow all instructions and warnings on the battery label and
package.
• Always insert batteries correctly with regard to polarity (+ and –),
marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new; or alkaline, standard (carbon-zinc) and
rechargeable (nickel cadmium or nickel metal hydride) batteries. Replace
all of them at the same time with new batteries of the same brand
and type.
• Remove dead batteries immediately and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
"Transporting batteries can possibly cause fires if the battery terminals
inadvertently come in contact with conductive materials such as keys,
coins, hand tools and the like. The US Department of Transportation
Hazardous Material Regulations (HMR) actually prohibit transporting
batteries in commerce or on airplanes (i.e. packed in suitcases and carryon
luggage) UNLESS they are properly protected from short circuits. So when
transporting individual batteries, make sure that the battery terminals are
protected and well insulated from materials that could contact them and
cause a short circuit."
HL2PKS_ManualENSP_072815.indd 6-7
6
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Stanley Headlamp. Read this
Instruction Manual and follow the instructions carefully before using
your new headlamp.

POWER SUPPLY

The unit is powered by three "AAA" alkaline dry cell batteries (may be
sold separately) inside the battery compartment.
Head lamp battery replacement/disposal
The head lamp is powered by three AAA alkaline batteries (may be sold
separately). The battery compartment is located on the back of the head
lamp. Refer to the illustrations below and the steps that follow to replace
the batteries:
1. Use one hand to hold the head lamp body and use the thumb on
the other hand to push down the back cover release button while
lightly applying force on the fastening buckle to gently pull out the
back cover.
2. Insert the batteries correctly according to the symbols shown inside
the battery compartment.
3. Replace the back cover by aligning it to the back cover release button.
4. Then snap the back cover into the head lamp body through the
bottom lock.
7
7/28/2015 4:29:35 PM