Care And Maintenance; Service Information - Stanley HL2PKS Manual De Instruccion

Ocultar thumbs Ver también para HL2PKS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing the batteries
1.
2.
WARNINGS: Refer to the safety warnings in the front of this instruction
manual when selecting and replacing batteries. Always dispose of used
batteries properly.
OPERATING THE HEAD LAMP
Adjust the strap to fit head size. Place the head lamp on your head and
turn the unit on by sliding the power slide switch either to the left for
solid light or to the right for flashing light. When not in use, turn the
unit off by sliding back the power slide switch to center position.

CARE AND MAINTENANCE

If the unit gets dirty, gently clean the outer surfaces of the headlamp
with a soft cloth moistened with a mild solution of water and detergent.
TROUBLESHOOTING
Head lamp will not operate
• Make sure the power slide switch is not at center position.
• The batteries may be completely discharged. Replace the batteries
following the directions given in the previous section.
• If the light does not operate after replacing the batteries, contact
manufacturer at (877) 571-2391.
HL2PKS_ManualENSP_072815.indd 8-9
3.
4.
8
ACCESSORIES
Recommended accessories for use with your tool may be available from
the manufacturer. If you need assistance regarding accessories, please
contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with
this appliance could be hazardous.

SERVICE INFORMATION

Whether you need technical advice, repair, or genuine factory
replacement parts, contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants this product against defects in materials
and workmanship for a period of ONE (1) YEAR from the date of retail
purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty
Period, the defective product can be replaced or repaired in the
following ways: (1) Return the product to the manufacturer for repair or
replacement at manufacturer's option. Proof of purchase may be required
by manufacturer. (2) Return the product to the retailer where product
was purchased for an exchange (provided that the store is a participating
retailer). Returns to retailer should be made within the time period of the
retailer's return policy for exchanges only (usually 30 to 90 days after the
sale). Proof of purchase may be required. Please check with the retailer
9
7/28/2015 4:29:35 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido