Product Features - HoMedics PGM-150-EU Guia De Inicio Rapido

PRODUCT FEATURES:

fig. 1
Massage heads
INSTRUCTIONS FOR USE:
Charging your device
1. To charge the product, plug the charging cable into a USB socket and
connect the cable to the charging socket on the bottom of the handle
(fig.2).
2. Once the charging cable is connected, the charging indicator LED will
illuminate and blink red. As soon as the device is fully charged the LED
indicator will change to blue.
3. Once the product is fully charged, disconnect it from the power supply.
4. The product requires 5-6 hours of charging for a full charge and will last
for approximately 1 hour of use.
WARNING If the voltage input exceeds 5V, the massager will terminate
charging and the indicating light will blink in blue in order to remind the user
to use the correct voltage adaptor. Adaptor output charging voltage of 5Vdc
and 1A must not be exceeded.
Using your device
1. Select the desired massage head and fasten it into the socket on
the front of the massager (fig.3). It should be finger tight only as
overtightening may cause damage to the product.
2. Press and hold the power on/off/power level button for 3 seconds to turn
the device on.
3. Pressing the on/off/power button again will cycle through the power levels:
• Press x 1: LO
• Press x 2: MID
• Press x 3: HI
Charging
indicator LED
On/off/power
button
Power socket
Operation
indicator light
USB charging
cable
Adaptor plug not
included
• Pressing the button again will repeat this sequence.
4. Gently move the massage head over the part of the body you wish to
massage at first, then gently apply more pressure as desired. If you are
a first time user it is recommended that you start on power level 1 and
press gently.
5. A long press on the on/off/power button for 1 second will turn the
massager off.
6. The product cannot be used while charging
DO NOT USE THE PRODUCT FOR OVER 30 MINUTES CONTINUOUSLY.
IF THE PRODUCT IS USED FOR OVER 30 MINUTES IT MAY TRIGGER THE
HEAT PROTECTION FEATURE AND STOP AUTOMATICALLY.
PLEASE WAIT FOR AT LEAST 30 MINUTES FOR THE PRODUCT TO COOL OFF
BEFORE RE-USING.
Cleaning your device.
• Make sure the device is unplugged from any power supply and allow to
cool before cleaning. Clean only with a soft, slightly damp sponge.
• Never allow water or any other liquid to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass/furniture polish, paint
thinner, etc to clean.
GB
2 I
fig. 2
fig. 3