Hama TH-100 Instrucciones De Uso página 6

All manuals and user guides at all-guides.com
• Press the ADJUST button (4) to display the maximum or minimum values
for temperature and humidity recording.
• Press the ADJUST button (4) for about 2 seconds to delete these
recordings and start recording again.
Note
If the ambient humidity is less than 20%, LL is shown in the
corresponding field on the display.
5.5 Alarm and hourly chime
• In alarm mode, press the ADJUST button to switch the alarms on or off.
The bell symbol stands for the alarm and the propeller symbol stands for
the clock hour. If one of these symbols appears on the display, the relevant
functions are activated.
• If the alarm is switched on, it will stop going off automatically after about
a minute or when the SNOOZE button (6) is pressed. If you press the
SNOOZE button (6), the alarm will go off again four times.
5.6 Moon phase display (2)
A B C
A: New moon
C: Half moon (first quarter)
E: Full moon
G: Half moon (last quarter)
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use
aggressive cleaning agents. Make sure that water does not get into the
product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of
the product or from failure to observe the operating instructions and/or
safety notes.
D E F
B: Waxing crescent
D: Waxing half moon
F: Waning full moon
H: Waning crescent
G H
5