Makita BTD044 Manual De Instrucciones página 6

A
► 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
Turning on the lamp
CAUTION:
• Do not look in the light or see the source of light
directly.
1
► 1. Lamp
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out approximately 10 sec-
onds after the switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
1
Auto-Stop setting for number of
impacts
This tool has a convenient auto-stop mechanism that
allows you to preset the desired number of impacts in
terms of the application. The tool then stops automati-
cally after reaching the preset number of impacts.
B
Setting for number of impacts
1
► 1. Display 2. Indication button
1. Pull the switch trigger, and then release it.
2. Pull the switch trigger approximately 3 seconds
while pressing the indication button, and then
release the switch trigger and the indication
button.
3. The lamp on the left side of the display blinks so
that the number of first digit can be changed by
pressing the button.
4. Press the button and choose the desired number.
The displayed number changes fast by keeping
pressing the button. To set the first digit, pull the
switch trigger and then release it.
5. The lamp on the right side of the display starts to
blink so that the number of second digit can be
changed.
6. Press the button and choose the desired number.
The displayed number changes fast by keeping
pressing the button. To set the second digit, pull
the switch trigger and then release it.
7. For the final setting, pull the switch trigger while
pressing the indication button. The number of
impacts is set at once.
To reconfigure the number of impacts, pull the
trigger without pressing the indication button so
that return to 3 above.
Confirming the current setting
number
To check the current setting number, pull the trigger
once, release it and then press the indication button.
6 ENGLISH
2