General Assembly Instructions - ArmorAll VO406S 0901 Manual Del Usuario

GENERAL ASSEMBLY INSTRUCTIONS

WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the container. (fig. 3)
4. Remove the contents from inside the container. Make sure you have all contents as listed on page 6. (fig. 4)
5. Insert the handle into the slots located on the top of the power head. (fig. 5)
6. For dry vacuum cleaning, install the supplied reusable cloth filter. (fig.6) See page 12 for filter installation.
7. For wet vacuum cleaning, install the supplied foam filter. (fig. 7) See page 12 for filter installation.
8. Place the power head back on the container, aligning the top section with the latches, and snap into place.
(fig. 8 & 9)
9. Insert the larger end of the hose into the desired port. (fig. 10)
10. Choose the desired accessories and insert onto the end of the hose. (fig. 11)
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a double polarized plug (with one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in
any way. Double insulation
power supply system.
All manuals and user guides at all-guides.com
eliminates the need for the three wire grounded power cord and grounded
7