Disassembly And Cleaning; Product Warranty - Össur Icelock 551 Instrucciones De Uso

3. After installation distribute silicone adhesive around the valve / socket contact point
to ensure an air tight seal.
4. Ensure the valve parts and airways are free from debris before final assembly.
5. Replace rubber membrane to cap. Ensure the concave surface is facing the cap cavity.
(Figure D)
NOTE: When reassembling ensure the membrane is ON the cap and NOT in the
housing.
6. Screw the cap on using the cap key.

DISASSEMBLY AND CLEANING

1. Unscrew the cap using the cap key.
2. Remove the rubber membrane carefully.
3. Clean all parts with water and mild detergent.
4. Hold down the release button while cleaning airways.
REASSEMBLY
1. Replace rubber membrane to cap. Ensure the concave surface is facing the cap cavity.
(Figure D)
2. Screw the cap on using the cap key.
NOTE: When reassembling ensure the membrane is ON the cap and NOT in the
housing.

PRODUCT WARRANTY

• ÖSSUR offers 6 months limited warranty on manufacturing faults.
6