König Electronic IR-URC31 + Manual De Uso página 3

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
B. Setup by Automatic Search
1. Switch on the device that you like to control. If it is a VCR insert a cassette.
2. Point the remote control at the device. Simultaneously press the SET and
Device buttons for three seconds. The LED should start flashing, that means
it is in Automatic Search now.
3. The OFF signal is automatically transmitted from the remote control to the
device (code scan). As soon as the device switches off, immediately press
any key (except SET key) to stop the Automatic Search.
4. Switch on the device again by pressing the "POWER" key. Check the function
of the other buttons on the remote control. If none of the buttons function
(i.e. the search cannot be stopped at the correct time) or the majority of the
buttons do not function correctly, restart the search (see steps 2 to 4) to
find a suitable code. If the majority of the buttons function correctly, setup
has been successful. Re-press the device button to save the code and to
terminate the setup mode.
Note: To automatically terminate the search, press any button (except the SET
button). The LED turns off and the search is terminated.
C. Setup by Manual Search
1. Switch on the device that you like to control.
2. Point the remote control at the device. Press and hold down the SET button
and then press the Device button. (For less than 3 seconds, otherwise Auto
search is started) Then release the two buttons.
3. The LED lights up and the remote is in setup mode.
4. Press the Power button (On/Off button) approx. every 1.5 seconds. (If the
device you are searching for is a DVD player, etc., you can also press the
play button.) The LED light should start flashing, i.e. the device is in Manual
Search Mode.
5. As soon as the device you are searching for switches off (or is reactive),
check whether the other buttons on the remote control function correctly
(do not press Power button, or else it will move to next code). If the majority
of the buttons does not function correctly, press the button approx. every
1.5 seconds to initiate the reactive code (manual search is continued, see
steps 4 to 5). If the majority of the buttons on the remote control functions
correctly, save the code by pressing the Device button to terminate the
manual search.
Note: The Manual Search is automatically terminated if no entry occurs during a
30 seconds period.
D. Display Device Code
You can call up the device code which you have set in your new remote control
as follows:
1. Press and hold the SET button, simultaneously press number 1 to display
the hundreds of the 3-figure code. Count how often the LED flashes. If the
LED does not flash, the number is Zero.
2. Press and hold the set button, simultaneously press number 2 to display the
tens of the 3-figure code.
3. Press and hold the set button, simultaneously press number 3 to display the
ones of the 3-figure code.
Example for Code 108:
1. Press SET and "1" LED flashes once
2. Press SET and "2" LED does not flash.
3. Press SET and "3" LED flashes eight times.
E. Volume Lock
This function is very practical if you wish to use just one device to control the
volume. In this case, you can use the function to set the volume and mute
button to AMP, regardless of which device you are using (even if you are using a
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ir-urc32

Tabla de contenido