Battery Replacement - HYGIPLAS GG748 Guia Del Usuario

High/Low temperature alarm setting
1. Press [SET] and the high (HI) limit value will flash.
2. Press [UP] or [DOWN] to set high limit. *
3. Press [SET] again and the low (LO) limit value will flash.
4. Press [UP] or [DOWN] to set low limit. *
5. Press [SET] to finish setting.
*During setting the limit value, holding down the [UP] or [DOWN] will increase/decrease the value
automatically. Press [ON/OFF] with turn the alarm off or on.
• When the reading is out of set limit the alarm will be on for 10 seconds and off for 5 seconds.
• Press any key to stop the alarm but the HI or LO icon still flashes until the reading is within the
limit.

Battery Replacement

1. Open the battery cover on the back case.
2. Replace the battery with the same type and close battery cover.
NOTE
1. Clean the probe after each measurement to avoid cross contamination.
2. Reset reading memory to current value before taking maximum/minimum reading.
3. Do not expose thermometer to temperatures over 50°C/122°F or use in ovens.
4. The thermometer cannot be switched off when the hold function is activated or the maximum/
minimum reading is being displayed.
Symbols
Symbol
LLLL
HHHH
Compliance
Dispose of depleted batteries in accordance with local regulations, within the
EC there are nominated disposal points for batteries.
The WEEE logo on this product or its documentation indicates that the product
must not be disposed of as household waste. To help prevent possible harm to
human health and/or the environment, the product must be disposed of in an
approved and environmentally safe recycling process. For further information
on how to dispose of this product correctly, contact the product supplier, or the
local authority responsible for waste disposal in your area.
HYGIPLAS parts have undergone strict product testing in order to
comply with regulatory standards and specifications set by international,
independent, and federal authorities.
HYGIPLAS products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
Every effort is made to ensure all details are correct at the time of going to press, however, HYGIPLAS reserve the right to
GG748_ML_130x210mm_v4_20220119.indb 3 GG748_ML_130x210mm_v4_20220119.indb 3
Description
Low battery voltage
1. Sensor open circuit
2. The reading is out of low range (-50°C)
1. Sensor short circuit
2. The reading is out of high range
(300°C)
mechanical, photocopying, recording or otherwise, without the prior written permission of HYGIPLAS.
change specifications without notice.
Action required
Replace the batteries
1. Return the thermometer for repair
2. Keep the measurement above low range
1. Return the thermometer for repair
2. Keep the measurement below high range
EN
3
2022/1/19 13:08 2022/1/19 13:08