OttLite AY5009-FFP Guia De Inicio Rapido

N
G
A
LED Desk Lamp with Sliding Dimmer
AY5009-FFP AY5G59-FFP
INS150223
J
G
K
M
H
L
M
D
C
E
English
CONGRATULATIONS!
You've purchased the finest in natural lighting technology with
your new OttLite ® product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and
return it today by mail, or register online by going to:
OttLite.com/warranty
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing placing lamp body base (A) flat
on a steady surface.
Connect the AC Adapter input (E) into connector (D) in the
2.
rear-bottom of the lamp.
3. Plug the A/C adapter (F) into a standard household 120V AC
outlet. Note: Only use with the supplied AC adapter to
avoid damage or fire.
4. Touch the ON/OFF button (L) to power on or power off the
lamp.
There are seven levels of brightness. Brightness can be
5.
adjusted by either touching or sliding a finger over the
dimmer panel (M). NOTE: If dimmer function was employed
prior to turning "OFF" lamp, the lamp will return to light
setting last employed unless disconnected from adapter.
6. To position the light adjust the arm (H) and/or rotate the shade
(J) until desired position is achieved. Please hold the lamp
F
base (A) while adjusting the lamp. Take care not to overextend
the lamp to avoid unbalancing it and damage. Please refer to
diagrams for lamp maximum adjustment range.
As needed, tighten or loosen the two pivot joints (G) with
7.
the enclosed allen key (N). Be careful to not over tighten
the joints.
Enjoy your OttLite LED Desk Lamp with Sliding Dimmer!
®
SAFETY WARNING:
FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
Turn lamp off and WAIT UNTIL LAMP HEAD (J) and
1.
ADAPTER (F) ARE COOL before handling.
The LED panel (K) might get hot after several hours of
2.
continuous use, DO NOT place your hands directly on
LED light panel.
Never use with an extension cord unless the plug can be
3.
fully inserted into the receptacles in the extension cord.
4. Do not alter the plug.
5. The lamp head included with this unit cannot be replaced by
the consumer.
T12U
LED Desk Lamp with Sliding Dimmer
NOTE: The important safety instructions appearing in
this instruction sheet are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution, and care must be
used with any electrical product.
CAUTION!
THIS LUmINaIRE IS DamagED, IT SHaLL bE ExCLUSIvELY REPLaCED bY
THE maNUFaCTURER OR ITS SERvICE agENT OR a SImILaR qUaLIFIED
PERSON IN ORDER TO avOID a HazaRD. INDOOR USE ONLY.
FCC PART 15
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
» Reorient or relocate the receiving antenna.
» Increase the separation between the equipment and receiver.
» Connect the equipment into an outlet on a circuit different from
that of the receiver.
» Consult the dealer or an experienced radio/TV technician
for help.
CAUTION:
not expressly recognized by OttLite Technologies voids
TO REDUCE THE RISK OF
OttLite's responsibility for proper function of product.
CAN ICES-3 (B) / NMB-3 (B)
AC/DC ADAPTER
Input: AC 100-240V, 50/60 Hz, 0.8A
Output: 12V DC, 1.5A with a Male DC Plug
THIS LAMP CONTAINS a 5V-2.1A USB output port (C) located
on the base of the lamp. USB port can charge such items as
tablets,cellular phones, etc.
IF THE ExTERNaL FLExIbLE CabLE OR CORD OF
Any change or modification to product
REV010716