OttLite SlimLine Task Lamp Guia De Inicio Rapido

B
C
A
SlimLine Task Lamp
315G53 315083 326003 326003-CA
383G53 383G53-CA
INS110013 REV051911
ENGLISH
CONGRATULATIONS!
You've purchased the finest in
natural lighting technology with your
new OttLite
®
PRODUCT REGISTRATION FORM
Please complete the enclosed
Product Registration Form and
return it today by mail, or
register online by going to:
http://warranty.OttLite.com.
WARNING: To prevent electric
shock, make sure the lamp is not
plugged in until all assembly steps
are complete.
LAMP ASSEMBLY
1. Align base as shown. Install base
screw (A) loosely by hand.
2. Tighten base screw until snug.
OPERATION
1. As needed, tighten or loosen the
two pivot joints (D) using a coin. Be
careful to not overtighten the joints.
2. Shade height and angle can be
D changed by grasping the shade and
base and moving it up or down.
3. The shade can also be rotated
right and left at the upper joint.
B
TUBE INSERTION/REPLACEMENT
D
1. Make sure the lamp is not plugged
into an electrical socket.
2. If the lamp has been in use, allow
it to cool approximately 5 minutes
before proceeding.
3. Raise the shade so access to the
tube is possible.
31700R 317PNR CAUTION!
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or its service agent or a similar qualified person in order to avoid a hazard. Indoor use only.
GX7825
SlimLine Task Lamp
4. To install a tube in the socket,
hold the tube firmly at the non-base
end with thumb and forefinger.
Align into socket, then press the
product.
base into the socket until it "snaps"
into place (B).
5. To remove a tube already installed
in the lamp, grasp it firmly at the free
end between thumb and forefinger.
Use free hand to push fingers and
tube away from the socket. Do not
twist or turn the tube.
CAUTION: Take care to prevent
the tube end from hitting the
shade. Tube breakage may result.
6. Return shade to desired position.
7. Plug lamp into a standard 120V,
60Hz socket. Your lamp is ready
to use.
8. Turn lamp on or off by pushing
switch (C) in.
Please note that in operation,
OttLite ® tubes are not dimmable.
Enjoy your OttLite
®
Lamp!
This lighting system is designed
for use with OttLite
(style number PL13-E).Use of
C
other products voids the warranty B
and may result in damage to the
lighting system.
For more information on purchasing
replacement tubes/bulbs please go to
www.OttLite.com/replacement13wtube
A
CAUTION! IMPORTANT SAFETY INSTRUCTIONS:
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A FEATURE TO
REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF
THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A
QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED. DO
NOT ALTER THE PLUG.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
AVERTISSEMENT! IMPORTANTES DIRECTIVES DE
SÉCURITÉ:
CETTE LAMPE PORTATIVE EST MUNIE D'UNE FICHE POLARISÉE (UNE LAME PLUS LARGE
QUE L'AUTRE). CE DISPOSITIF DE SÉCURITÉ DIMINUE LE RISQUE DE CHOCS ÉLECTRIQUES PUISQUE LA FICHE
NE S'INSÈRE DANS LA PRISE QUE D'UN SEUL CÔTÉ. SI ELLE N'ENTRE PAS DANS LA PRISE, INVERSEZ-LA. SI ELLE
N'ENTRE TOUJOURS PAS, CONTACTEZ UN ÉLECTRICIEN QUALIFIÉ. N'UTILISEZ JAMAIS AVEC UNE RALLONGE SAUF
SI LA FICHE S'INSÈRE ENTIÈREMENT. NE MODIFIEZ PAS CE DISPOSITIF DE SÉCURITÉ.
AVERTISSEMENT:
DANS LA GRANDE FENTE ET POUSSEZ JUSQU'AU BOUT.
SlimLine Task
¡ PRECAUCIÓN! INSTRUCCIONES DE SEGURIDAD
type bulbs
®
IMPORTANTES:
ESTA LÁMPARA PORTÁTIL TIENE UN ENCHUFE POLARIZADO (UNA DE SUS PATAS
ES MÁS ANCHA QUE LA OTRA) COMO CARACTERISTICA PARA REDUCIR EL RIESGO DE UNA DESCARGA ELÉCTRICA.
ESTE ENCHUFE ENCAJARÁ EN CUALQUIER TOMACORRIENTE POLARIZADO SOLO DE UNA MANERA. SI EL ENCHUFE
NO CALZA COMPLETAMENTE EN EL TOMACORRIENTE DÉLE LA VUELTA. SI AÚN NO ENCAJA, PÓNGASE EN
CONTACTO CON UN ELECTRICISTA CALIFICADO. NUNCA UTILICE UNA EXTENSIÓN A NO SER QUE EL ENCHUFE
PUEDA SER TOTALMENTE INSERTADO. NO ALTERE EL ENCHUFE.
PRECAUCIÓN:
PARA PREVENIR UNA DESCARGA ELÉCTRICA, HAGA COINCIDIR LA PATA ANCHA DEL
ENCHUFE CON LA RANURA ANCHA, INSERTE TOTALMENTE.
POUR ÉVITER LES CHOCS ÉLECTRIQUE, INSÉREZ LE BOUT LARGE DE LA FICHE