Overview Of The Components - AEG SRP 4343 iP Instrucciones De Servicio

CAUTION:
Do not touch the speaker membranes (A) with your hands
or with objects. This may damage the membranes.

Overview of the components

1 CD compartment
2 CD tray lock (OPEN/LOCK)
3 VOLUME control (volume)
4 Docking port
5 MUTE button
6 button (Stop)
7 button (play/pause)
8 / buttons (search forward/backwards)
9 PROG button (Memory)
10 AUX IN jack
11 IR sensor for the remote control
12 MODE function switch
13 EQ button (Equalizer)
14 button (standby/power)
15 LCD display
16 BASS control (Bass)
17 Nylon handle mounting
18 Telescopic antenna
A Speaker
Rear view (not shown)
POWER ON/OFF switch
DC IN 12 V Power supply connection
Battery compartment
Remote control
1 STANDBY button
2 EQ button
3 PROG button
4 APPLE CONTROL buttons
/ Menu navigation
OK (Confirm)
MENU (select previous menu)
5 PLAY/PAUSE (play/pause) button
6 / SKIP/TUNING UP button (search forward)
/ SKIP/TUNING DOWN button (search backwards)
7 STOP / FM MONO/ST button
8 VOLUME +/- buttons
9 RANDOM/ID3 button (random playback)
10 REPEAT/INTRO button
11 PRESET/FOLDER DN/UP buttons (radio station memory
/ Album selection)
12 MUTE button
13 MODE function switch
Installation/Introduction
• Read the manual thoroughly before operating the de-
vice!
• Select a suitable location for the device. Suitable loca-
tions are dry, even and anti-slip surfaces on which you
may operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
WARNING:
Turning up the volume too high may damage your hearing.
Power supply
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz. Connect the device with the
plug connector by inserting its plug into the DC IN 12 V
jack of the device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• The included AC adapter may only be used with this
device. Do not use it for other devices.
• Use only an AC adapter with 12 V (
AC adapter may damage the unit.
• The mains plug shall remain readily operable.
• The direct plug-in adapter is used as the disconnect
device, the disconnect device shall remain readily
operable.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• The preset time and station is lost as soon as the power
supply has been interrupted.
Battery Operation (Batteries not supplied)
• Open the lid of the battery compartment on the rear
side.
• Insert the 10 batteries type UM1/R20 1.5 V. Observe the
correct polarity (see bottom of battery compartment)!
• Close the battery compartment.
Should the device not be used for a long periods, remove
the batteries, to prevent any "leakage".
NOTE:
• If a mains cable is connected, the batteries are auto-
matically switched off.
• The preset time station is lost as soon as you remove
the batteries.
English
41
). A different