OttLite V23WGT Guia De Inicio Rapido

B
L
A
K
C
D
G
DO NOT USE SHADE
NO UTILICE LA PANTALLA
H
I
L'ABAT-JOUR DANS
J
18w Floor Lamp
V23WGT V23002
INS-14-0110
IN THIS AREA
EN ESTA AREA
NE PAS PLACER
CETTE ZONE.
English
CONGRATULATIONS!
You've purchased the finest in natural lighting technology with
your new OttLite product.
®
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and
return it today by mail, or register online by going to:
OttLite.com/warranty.
CAUTION: Tip hazard. Do not move shade or accessories
outside of the shaded area as shown in Figure 1. Shade and
accessories must be kept within the shaded area and must align
in the same forward-facing direction as the base.
WARNING! To prevent electrical shock, make sure the lamp is
not plugged in until all assembly steps are complete.
LAMP ASSEMbLy
1. Remove lamp from packing. To ease assembly, straighten
Flex-Neck (A) so that shade (b), neck, and pole (C) are in a
straight line.
2. Place the lamp base (D) on a flat steady surface (the floor).
3.
Firmly insert foot (G) of pole (C) into hole in base (D), then lay
the lamp on its side with the bottom of the base.
4. Remove hardware (H, I, J) from the plastic bag included with
the base.
5. Place lock washer (I), then flat washer (H) over bolt (J); insert
the bolt into the bottom of the base (D) to engage the pole.
6.
Tighten bolt (J) turning clockwise until firm.
7. Set the lamp upright.
8.
Install tube (K) following TUbE INSERTION/
REPLACEMENT instructions.
9.
Plug the lamp into a standard 120V outlet.
10. Position shade (B) as desired by flexing the neck. To avoid
lamp breakage, DO NOT FORCE the neck to bend.
11. To turn the lamp ON or OFF, depress the push-button switch
(L) located at pole end of shade (b).
CAUTION! IMPORTANT SAFETY INSTRUCTIONS:
FIGURE 1
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A FEATURE TO REDUCE THE RISK OF ELECTRIC
SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE
PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY
Usable area for
INSERTED. DO NOT ALTER THE PLUG.
shade
Area útil para la IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE
MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID A HAZARD. INDOOR USE ONLY.
pantalla
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Zone sécuritaire
pour l'abat-jour
This product complies with Part 18 of FCC Rules, but may cause interference to radios, televisions, wireless telephones, and remote controls.
Avoid placing this product near these devices. If interference occurs, move the product away from the device or plug either into a different
outlet. Do not install this product near maritime safety equipment or other critical navigation or communication equipment operating between
0.45-30 MHz.
PL7961F
18w Floor Lamp
TUbE INSERTION & REPLACEMENT
1. Make sure the lamp is not plugged into an electrical socket.
2.
If the lamp has been in use, allow it to cool for approximately 5
minutes before proceeding.
3. Set the lamp upright on the floor.
4.
To install a tube (K) in the shade (b) socket, grasp the tube
securely with your hand. Lay the tube flat then push the tube
into the shade clip. Align the tube base and pins with the
socket and receptacles then and push the tube straight into
the socket until it "snaps" into place. DO NOT apply pressure
on the glass end of the tube.
5.
To remove a tube already installed in the lamp, grasp the tube
firmly in your hand and angle it slightly out of the shade clip;
using a slight side to side motion, pull it straight out of the
socket. Do not twist or turn the tube while removing it from
the socket.
Enjoy your OttLite 18w Floor Lamp!
Please note that in operations, OttLite tubes are not
dimmable.
This lighting system is designed for use with OttLite
tubes (Style Number PL18-B). Use of other products
voids the warranty and may result in damage to the
lighting system.
REV041714
® type