For Your Safety; Tool Specifications; Intended Use - Master ICSS 300-P Instrucciones De Uso

ICSS300 P.book Seite 11 Donnerstag, 6. Dezember 2007 10:06 10
GB
Read the operating instructions!
Working safely with this device is pos-
sible only when the operating instruc-
tions and safety warnings are read
completely, and the instructions contained therein
are strictly followed. Additionally, the general
safety warnings in the enclosed leaflet must also
be followed.
Danger of electric shock! If the mains
cable or the connection cables are
damaged or cut-through during work-
ing, do not touch them, but immedi-
ately pull the mains plug. Never operate the device
with damaged cables.
Danger of burning! Wear protective
gloves! During the working proce-
dure, the burner and the workpiece
being worked, heat up intensively.
Danger of irritation and chemical
burns! Wear safety glasses/goggles
and protective gloves!
The fluids being used can lead to irri-
tation and chemical burns to the eyes
and skin.
If fluid should come in contact with the
skin, wash the respective skin area im-
mediately with water and soap. If fluid
should come into contact with the

Tool Specifications

Welding-seam Cleaner ICSS 300-P
Article number 0702 353 500
Mains voltage 230 V, 50/60 Hz
Rated power input 300 W
Electrode voltage 12 V/30 V (AC/DC)
Protection class IP23
Dimensions 200x210x85 mm
Weight, approx. 3,4 kg
Cleaning agent
Article number 0893 984 800
Filling quantity 100 ml
Polishing agent
Article number 0893 984 803
Filling quantity 100 ml

For Your Safety

eye(s), rinse/flush eye(s) with clear water for at
least 10 minutes and consult a doctor without de-
lay!
If fluid comes into contact with sensitive materials,
such as clay, marble, china, etc., damage may oc-
cur.
of tanks, silos, etc., the vapours must be disposed
of via a suitable extraction device.
Do not use other products than those listed, and
do not mix these with other chemicals. Store the
fluids in the original bins/containers in a safe
location.
Do not perform any maintenance or cleaning
on the device until it has been disconnected
from the power supply.
Have damaged components replaced only with
original spare parts.
Use only original Würth parts and accesso-
ries.
For further notes on safety refer to the enclosed sheet.
The device is intended for cleaning and polishing
oxide and burn stains on precious metals, which
have developed during welding and cutting. Only
original Würth cleaning and polishing agents may
be used.
When using the marking set, which is available as
an additional accessory, the device is intended for
marking and eroding of steel.
However, the device may not be used for steels that
react particularly sensitive to the electrolyte being
used, e.g., ALSI 430, which can lead to the forma-
tion of white rings.
When in doubt, please refer to your Würth repre-
sentative or carry out a test on a sample first.
For damage caused by usage other then intended,
the user is responsible.
Provide for good ventilation! Prevent
the operator or other persons in the
close vicinity from being subjected to
the harmful vapours. If the device is
operated in enclosures, such as inside

Intended Use

11